Eight characteristics and working procedures of LPG high speed centrifugal spray dryer

LPG high speed centrifugal spray dryer only takes 5 to 15 seconds to dry liquid material. The spray dryer is very suitable for heat sensitive materials. The product processed by this equipment has high quality and purity, good uniformity, fluidity and solubility

Characteristics of LPG high speed centrifugal spray dryer

1. LPG high speed centrifugal spray dryer needs only 5 to 15 seconds to dry liquid material.

2. the spray dryer is very suitable for heat sensitive materials.

3. The product treated by this equipment has high quality and purity, good uniformity, fluidity and solubility.

4. In hot air flow, 95% to 98% of water can evaporate instantaneously.

The 5. LPG centrifugal spray dryer is simple and easy to operate. It is very suitable for continuous production.

6. the spray dryer can adjust the diameter, density and moisture content of the product by changing the operating conditions within a certain range.

7. The liquid with moisture content of 40% to 60% (for special materials, the content can reach more than 90%) can be dried into powder or granular product once.

8. After drying, there is no need for crushing and sorting. Therefore, the operation steps are reduced and the purity of the product is improved.

Working procedure of LPG centrifugal spray dryer

1. after filtration and heating, hot air enters the air distributor at the top of the spray dryer.

2. By passing through a high-speed centrifugal atomizer at the top of the tower, the material will be rotated and sprayed into very fine droplets.

3. The material can be dried into final product by short time hot air contact.

4. The finished product will be continuously discharged from the bottom of the drying tower and discharged from the cyclone separator. The exhaust gas is discharged by the fan.