Special belt dryer for gypsum board

Changzhou Haomai drying jet air dryer is mainly used for fiberboard, gypsum board, carton board, pulp mold, coating drying and so on. It is also suitable for the drying of sheet materials and some special materials. Jet air dryer, gypsum board jet air dryer, fiberboard jet airflow drying

Project classification: gypsum board special belt dryer selected products: DW series jet airflow belt dryer

Project Description: Changzhou Haomai drying jet air dryer is mainly used for fiberboard, gypsum board, carton board, pulp mold, coating drying, etc., and also suitable for drying sheet materials and some special materials. Jet air dryer, gypsum board jet air dryer, fiberboard jet airflow drying

1、 Project Overview:

Haomai drying jet air dryer is mainly used for fiberboard, gypsum board, carton board, pulp mold, coating drying and so on. It is also suitable for the drying of sheet materials and some special materials. The working principle of jet air dryer, gypsum board jet airflow dryer and fiberboard jet airflow dryer is to dry wet materials in two steps. The raw materials are first dried by the mixture of high temperature and low humidity exhaust gas and hot gas supplement gas for primary positive pressure drying. The used high humidity and low temperature tail gas is discharged out of the machine. The dried semi-finished products are dried by fresh hot air under secondary negative pressure, and the dried finished products are metered and packaged, so as to complete a good cycle drying process. The supplementary hot air can be adjusted according to the need, so the machine has wide applicability.

2、 Equipment Overview:

DW type jet airflow belt drying type, hot air from the slit or hole bundle flows down or up to the material on the conveyor belt at the same time. As the jet gas velocity is higher than 15m / s, the convective heat transfer film is extremely thin, the heat transfer coefficient is large, and the drying speed is fast. When the equipment is used for airtight materials, the upper jet air still returns to the upper part, and the lower part still returns to the lower part, and then participates in the circulation.

It has strong penetrability to air flow of air permeable material and diffusibility inside material. The heat source can be steam, electricity, hot blast stove and oil fume ventilation.

3、 Equipment Description:

Jet airflow belt drying equipment, such as pulp drying is generally S-shaped or M-shaped multi-layer structure, large-scale pulp mold is single-layer type. The former is of hanging blue type, and the latter is of mesh belt conveying type. In addition, the temperature of hot air, the amount of circulating gas, humidity, air velocity and the form of air beam are not common to other materials, and the actual difference is great.